DIY fabric-covered lampshade & ball finial

1. Cover your work surface with butcher paper, then lay your fabric wrong side up. Place the lampshade in the middle and roll from end to end (it rolls in a semi-circle pattern) to determine if your piece of fabric is big enough to cover the shade. (You can also use this method to create a paper pattern with butcher paper, which wouldn’t require the trimming described below.)

2. Spray the middle section of the fabric with adhesive, then place the shade on top. Roll the shade and smooth the fabric. Continue spraying, rolling, and smoothing until the shade is covered and the excess fabric meets at the lampshade’s seam.

3. Trim the excess fabric so that one side overlaps about 1 inch. Fold over that side and glue down.

4. Trim the top and bottom edges about 3/4 inch longer than the shade. Fold the edges over the edge of the shade and hot glue to the inside.

5. Starting at the seam, hot glue your trim along the top and bottom edges of the shade. Glue a few inches at a time using a thin solid line of glue. Overlap the trim about 1/2 inch at the seam. Dab the ends with craft glue to keep them from fraying.

1. Place the wooden ball on a drop cloth (outside). Spray one coat of primer, and let dry. Flip it over and spray the other side. Let dry. Likewise, spray two coats of paint on each side, letting it dry between coats.

2. After the paint dries for several hours, attach the ball to your lamp’s original finial. The brass finial from my lamp fit perfectly into the hole of the ball. All I had to do was press them together for it to fit snugly. Depending on the size of your finial, you may have to glue it—or buy a new finial. This one might work.